Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: View of Knock Sensor

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

IMPORTANT: The KS threaded surfaces must be clean before installation.

Install the knock sensor.
Tighten: Tighten the knock sensor retaining bolt to 25 N.m (18 lb ft).
Connect the knock sensor harness connector.
Install the starter. Refer to Starter Motor Replacement (RPOs L61/LE5) or Starter Motor Replacement (RPO LSJ) in Engine Electrical.