LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Intake Air Temperature (IAT) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating ECT Sensor, Boost Control Solenoid, & IAT Sensor
    GM1389396Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the intake air temperature (IAT) sensor harness connector.
  2. Remove the IAT sensor bolt.
  3. While twisting the IAT sensor (3), pull the sensor from the engine.
scientia non olet · About LEMON Manuals