LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
Fig 1: Installing The Fuel Tank Pressure Sensor To The EVAP Canister
GM1742792Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel tank pressure sensor to the EVAP canister. Ensure that the sensor grommet is fully seated to the canister.
    2. Fig 2: Connecting The EVAP Canister Harness Electrical Connector
    GM1652166Courtesy of GENERAL MOTORS CORP.
  2. Connect the EVAP canister harness electrical connector (1) to the fuel tank pressure sensor.
  3. Lower the vehicle.
scientia non olet · About LEMON Manuals