LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Level Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
CAUTION: Refer to Gasoline/Gasoline Vapors Caution in Cautions and Notices.
    Fig 1: View Of Fuel Level Sensor Tabs
    GM889989Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel pump module assembly. Refer to Fuel Pump Module Replacement .
  2. Push clockwise on the pressure sensor (1) in the 2 locations shown until an audible click is heard.
  3. Raise the pressure sensor until the sensor is removed from the bucket.
  4. Disconnect the fuel level sensor electrical connector (1) from the module cover.
  5. Remove the fuel level sensor electrical connector wiring (2) from around the fuel pipe.
  6. Push in the fuel level sensor retaining tabs (3) in order to disengage the sensor tabs from the module bucket.
  7. Slide the fuel level sensor (1) up and out from the module bucket.
scientia non olet · About LEMON Manuals