LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Level Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Fuel Level Sensor Tabs
    GM889989Courtesy of GENERAL MOTORS CORP.
  1. Slide the fuel level sensor (1) in and down into the module bucket.
  2. Ensure that the fuel level sensor retaining tabs (3) are fully engaged to the module bucket.
  3. Wrap the fuel level sensor electrical connector wiring (2) around the fuel pipe.
  4. Connect the fuel level sensor electrical connector (1) to the module cover.
  5. Align the pressure sensor (1) to the hole in the bucket.
  6. Push down and install the sensor to the bucket. Ensure that the sensor is secured to the bucket.
  7. Install the fuel pump module. Refer to Fuel Pump Module Replacement .
scientia non olet · About LEMON Manuals