LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Filler Tube Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
CAUTION: Refer to Gasoline/Gasoline Vapors Caution in Cautions and Notices.
Fig 1: Disconnecting The Fuel Fill Vent Pipe Quick Connect Fitting
GM1656958Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel fill cap.
  2. Drain the fuel tank. Refer to Fuel Tank Draining Procedure .
  3. Remove the fuel filler pocket. Refer to Fuel Filler Pocket Replacement in Body Rear End.
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  5. Disconnect the evaporative emission (EVAP) vent pipe (1) from the EVAP canister. Refer to Quick Connect Fitting(s) Service (Metal Collar) .
  6. Cap or plug the EVAP canister fitting in order to prevent system contamination.
    7. Fig 2: Removing The Fuel Fill Pipe Lower Bolt
    GM1656988Courtesy of GENERAL MOTORS CORP.
  7. Remove the fuel fill pipe lower bolt.
    8. Fig 3: Disconnecting The Fuel Tank Vent Line Quick Connect Fitting
    GM1656960Courtesy of GENERAL MOTORS CORP.
  8. Disconnect the fuel tank vent line quick connect fitting (2) from the fill pipe recirculation line. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  9. Loosen the fuel fill hose clamp (3) at the fuel tank.
  10. Remove the fuel fill hose from the fuel tank.
  11. Cap or plug the fuel tank opening and vent line in order to prevent fuel loss and/or system contamination.
  12. Remove the fuel fill hose/pipe.
scientia non olet · About LEMON Manuals