LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Filler Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
Fig 1: Disconnecting The Fuel Tank Vent Line Quick Connect Fitting
GM1656960Courtesy of GENERAL MOTORS CORP.
  1. Remove the caps or plugs from the fuel tank opening and vent line.
  2. Install the fuel fill hose to the fuel tank. Align the "D" notch on the fill hose (1) with the "D" notch on the fuel tank (1).
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Tighten the fuel fill hose clamp (3) at the fuel tank.

    Tighten:  Tighten the clamp to 4.5 Nm (40 lb in).

  4. Connect the fuel tank vent line quick connect fitting (2) to the fill pipe recirculation line. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
    5. Fig 2: Locating Fuel Filler Pipe Assembly Lower Retaining Bolt
    GM879143Courtesy of GENERAL MOTORS CORP.
  5. Install the fuel fill pipe lower bolt.

    Tighten:  Tighten the bolt to 10 Nm (89 lb in).

    6. Fig 3: Connecting The Fuel Fill Vent Pipe Quick Connect Fitting (1)
    GM1656958Courtesy of GENERAL MOTORS CORP.
  6. Remove the cap or plug from the EVAP canister fitting.
  7. Connect the fuel fill vent pipe quick connect fitting (1) to the EVAP canister. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  8. Lower the vehicle.
  9. Install the fuel fill pocket. Refer to Fuel Filler Pocket Replacement .
  10. Refill the fuel tank.
scientia non olet · About LEMON Manuals