LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
Fig 1: Disconnecting The Evaporative Emission Canister Harness Electrical Connector
GM1652166Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Disconnect the evaporative emission (EVAP) canister harness electrical connector (2) from the EVAP vent solenoid valve.
  3. Clean away any debris that may be present around the EVAP canister vent solenoid valve.
    4. Fig 2: Identifying EVAP Canister Retaining Bolt
    GM1652165Courtesy of GENERAL MOTORS CORP.
  4. Remove the EVAP canister retaining bolt (1).
  5. Lower the EVAP canister.
    6. Fig 3: Rotating EVAP Canister Vent Valve
    GM889735Courtesy of GENERAL MOTORS CORP.
  6. Rotate the EVAP canister vent valve counterclockwise to release from the locked position.
    7. Fig 4: View Of EVAP Canister Vent Valve
    GM889736Courtesy of GENERAL MOTORS CORP.
  7. Remove the vent valve from the EVAP canister.
scientia non olet · About LEMON Manuals