LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
Fig 1: View Of EVAP Canister Vent Valve
GM889736Courtesy of GENERAL MOTORS CORP.
  1. Insert the EVAP canister vent solenoid valve into the EVAP canister, with the valve aligned to the released position.
    2. Fig 2: Rotating EVAP Canister Vent Valve
    GM889735Courtesy of GENERAL MOTORS CORP.
  2. Rotate vent valve clockwise to secure into the locked position.
    NOTE: Refer to Fastener Notice in Cautions and Notices
    3. Fig 3: Locating EVAP Canister Retaining Bolt
    GM889739Courtesy of GENERAL MOTORS CORP.
  3. Install the EVAP canister and retaining bolt (1).

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 4: View Of EVAP Canister Vent Solenoid Valve Electrical Connector
    GM879141Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical connector to the EVAP canister vent valve.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals