LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Canister Assembly
    GM889740Courtesy of GENERAL MOTORS CORP.
  1. Insert the retaining tab of the EVAP canister into the slotted bracket on the vehicle underbody.
    Fig 2: Locating EVAP Canister Retaining Bolt
    GM889739Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the EVAP canister retaining bolt (1).

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    3. Fig 3: View Of EVAP Pipes
    GM889726Courtesy of GENERAL MOTORS CORP.
  3. Connect the hose connections (1, 2, 3) to the EVAP canister.
    4. Fig 4: View Of EVAP Canister Vent Solenoid Valve Electrical Connector
    GM879141Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical connector to the EVAP canister vent solenoid valve.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals