LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the EVAP canister purge valve on to the purge bracket.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: View Of EVAP Canister Purge Valve
    GM1387197Courtesy of GENERAL MOTORS CORP.
  2. Install the EVAP canister purge valve and bracket.

    Tighten:  Tighten the purge bracket nut to 8 N.m (71 lb in).

  3. Connect the purge pipe to the EVAP canister purge valve.
  4. Connect the vacuum pipe to the EVAP canister purge valve.
  5. Connect the EVAP canister purge valve harness connector.
scientia non olet · About LEMON Manuals