LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the starter. Refer to Starter Motor Replacement (RPOs L61/LE5) or Starter Motor Replacement (RPO LSJ) in Engine Electrical.
    2. Fig 1: Locating CKP Sensor
    GM1389391Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the crankshaft position (CKP) sensor electrical connector.
  3. Remove the CKP sensor bolt.
  4. Remove the CKP sensor (2).
scientia non olet · About LEMON Manuals