LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Boost Control Solenoid Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
Fig 1: Locating ECT Sensor, Boost Control Solenoid, & IAT Sensor
GM1389396Courtesy of GENERAL MOTORS CORP.
NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the boost control solenoid (2) and bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  2. Connect the boost control solenoid connector.
scientia non olet · About LEMON Manuals