LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Barometric Pressure (BARO) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating SCIP Sensor & BARO Sensor
    GM1389393Courtesy of GENERAL MOTORS CORP.
  1. Install the BARO sensor (2).
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the BARO sensor bracket and bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  3. Connect the BARO sensor harness connector.
scientia non olet · About LEMON Manuals