LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
Fig 1: View Of Air Cleaner
GM1386447Courtesy of GENERAL MOTORS CORP.
IMPORTANT: Verify full engagement of the inlet onto the resonator neck.
  1. Position the air cleaner assembly.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the air cleaner assembly attachment bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    3. Fig 2: View Of Air Intake Duct
    GM1386445Courtesy of GENERAL MOTORS CORP.
  3. Connect the air cleaner resonator to the air cleaner assembly.

    Tighten:  Tighten the air cleaner outlet duct clamps to 5 N.m (44 lb in).

scientia non olet · About LEMON Manuals