LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 2.0L - Introduction (2 Of 2)) >> Repair Instructions >> Accelerator Pedal with Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Accelerator Pedal Position Assembly
    GM898158Courtesy of GENERAL MOTORS CORP.
  1. Install the upper attachment bolt into the APP assembly.
  2. Install the APP assembly into the vehicle.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the attachment bolts into the APP assembly.

    Tighten:  Tighten the accelerator pedal position assembly-to-brake bracket bolt to 9 N.m (80 lb in).

  4. Connect the APP sensor harness connector. Push the connector in until the lock position is felt, then pull back to confirm engagement.
  5. Install the APP sensor connect CPA.
scientia non olet · About LEMON Manuals