Circuit/System Verification
WARNING: This page is about a different car, the 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
An open or a short to voltage in the control circuit will cause both the Ckt. Open Test Status and the Ckt. Short Volts Test Status parameters to display Fault.
- Ignition ON, command the fuel pump relay ON and OFF with a scan tool while observing the following control circuit status parameters:
- Fuel pump relay Ckt. Short Gnd Test Status
- Fuel pump relay Ckt. Open Test Status
- Fuel pump relay Ckt. Short Volts Test Status
- Each parameter should toggle between OK and Not Run, or Not Run and OK.