Circuit/System Testing

P0324

• If P0327, P0328, P0332, or P0333 are also set, preform those diagnostics first.
• This DTC indicates an internal ECM circuitry failure. Replace the ECM.

P0327, P0328, P0332, and P0333

IMPORTANT: If the KS lead is damaged in any way, replace the KS.
1. Ignition ON, engine OFF.
2. Disconnect the appropriate KS harness connector.
3. Measure for 2-5 volts between each of the following circuits and ground on the ECM side of the harness connector:
   • The KS signal circuit, terminal A
   • The KS signal circuit, terminal B
   • If less than the specified range, test the circuits for a short to ground or an open/high resistance. If the circuits test normal, replace the ECM.
   • If greater than the specified range, test the circuits for a short to voltage. If the circuits test normal, replace the ECM.
4. If the circuits test normal, replace the KS.

P0326 and P0331

IMPORTANT: If DTC P0335 or P0336 are also set, diagnose those DTCs first.
• Inspect for a loose or broken vehicle accessory or accessory bracket.
• Inspect for excessive engine mechanical noise.