Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Engine Oil Pressure Sensor

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the engine oil pressure sensor.
Tighten: Tighten the sensor to 22 N.m (16 lb ft).

Fig 2: View Of Knock Sensor (KS) Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the engine harness electrical connector (2) to the oil pressure sensor.
Lower the vehicle.