LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 791 (Engine Mechanical - 2.4L) >> Repair Instructions - On Vehicle >> Drive Belt Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Drive Belt Routing
    GM1571093Courtesy of GENERAL MOTORS CORP.
  1. Install and position the drive belt around all of the pulleys except for the drive belt tensioner.
  2. Install the J 44811  to the drive belt tensioner.
  3. Using the J 44811  , rotate the tensioner counterclockwise.
  4. Position the drive belt under the tensioner pulley.
    5. Fig 2: View Of Drive Belt Tensioner And Special Tool
    GM854300Courtesy of GENERAL MOTORS CORP.
  5. Using the J 44811  , rotate the tensioner clockwise in order to seat the tensioner pulley onto the drive belt.
  6. Install the engine splash shield. Refer to Engine Splash Shield Replacement .
scientia non olet · About LEMON Manuals