LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 790 (Engine Mechanical - 2.0L) >> Repair Instructions - On Vehicle >> Camshaft Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Camshaft Cover
    GM1382305Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the camshaft cover and bolts.

    Tighten:  Tighten the camshaft cover bolts to 10 N.m (89 lb in).

  2. Install the ground strap to the camshaft cover.

    Tighten:  Tighten the ground strap stud to 10 N.m (89 lb in).

    3. Fig 2: View OF Ignition Coils
    GM1387190Courtesy of GENERAL MOTORS CORP.
  3. Install the ignition coils. Refer to Ignition Coil Replacement .
  4. Connect the fuel feed pipe to the fuel rail.
  5. Install the fuel pipe bracket.

    Tighten:  Tighten the fuel pipe bracket bolt to 10 N.m (89 lb in).

  6. Connect the PCV hose to the cam cover.
scientia non olet · About LEMON Manuals