Camshaft Cover Installation

WARNING: This page is about a different car, the 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Camshaft Cover Assembly

Courtesy of GENERAL MOTORS CORP.

Assemble the camshaft cover and gasket. Ensure that the gasket is located in the retaining groove in the camshaft cover.

NOTE: Refer to Fastener Notice

Install the cover on the cylinder head and hand start the bolts.

Fig 2: Identifying Front Lift Bracket

Courtesy of GENERAL MOTORS CORP.

Install the front lift bracket.
Install the front lift bracket bolts.
Tighten: Tighten the bolts to 25 N.m (18 lb ft).

Fig 3: Identifying Rear Lift Bracket

Courtesy of GENERAL MOTORS CORP.

Install the rear lift bracket.
Install the rear lift bracket bolts.
Tighten: Tighten the bolts to 25 N.m (18 lb ft).

Fig 4: Identifying Ignition Coils

Courtesy of GENERAL MOTORS CORP.

Install the ignition coils.
Tighten: Tighten the ignition coil bolts to 10 N.m (89 lb in).
Tighten the camshaft cover bolts.
Tighten: Tighten the camshaft cover bolts to 10 N.m (89 lb in).

IMPORTANT: The solenoid valves are marked intake and exhaust.

Install the camshaft position actuator solenoid valves.
Install the camshaft position actuator solenoid valve bolts.
Tighten: Tighten the camshaft position actuator solenoid valve bolts to 10 N.m 89 lb in.