LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 789 (Engine Exhaust System) >> Repair Instructions >> Wheel Drive Shaft Heat Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wheel Drive Shaft Heat Shield
    GM878832Courtesy of GENERAL MOTORS CORP.
  1. Install the wheel drive shaft heat shield into position on the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the wheel drive shaft heat shield bolt to the engine block.

    Tighten:  Tighten the bolt to 30 N.m (22 lb ft).

  3. Install the wheel drive shaft heat shield bolt to the transaxle mount bracket.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  4. Lower the vehicle.
scientia non olet · About LEMON Manuals