LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 789 (Engine Exhaust System) >> Repair Instructions >> Catalytic Converter Replacement (LE5) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Catalytic Converter
    GM1650757Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW gasket onto the exhaust manifold studs.
  2. Install the catalytic converter to the exhaust manifold.
    3. NOTE: Refer to Fastener Notice .
  3. Install the exhaust manifold to the catalytic converter nuts.

    Tighten:  Tighten the catalytic converter nuts to 50 N.m (37 lb ft).

    4. Fig 2: View Of Catalytic Converter
    GM1650814Courtesy of GENERAL MOTORS CORP.
  4. Install a NEW gasket onto the resonator pipe studs.
  5. Install the catalytic converter to resonator pipe nuts.

    Tighten:  Tighten the resonator pipe nuts to 30 N.m (22 lb ft).

  6. Install the heated oxygen sensor (HO2S). Refer to Heated Oxygen Sensor 2 Replacement .
  7. Inspect the exhaust system for leaks.
scientia non olet · About LEMON Manuals