LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 782 (Engine Control System & Fuel System - 2.4L - DTC P0351 To DTC P2544) >> DTC P0442 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
  • Larger volume fuel tanks and/or those with lower fuel levels may require several minutes for the floating indicator to stabilize.
  • Refer to J 41413-200  operation manual for detailed instructions in Evaporative Emission System Diagnosis .
  1. Connect the J 41413-200  to the vehicle service port. For vehicles without a service port, disconnect the purge tube at the quick connector on the EVAP canister side of the EVAP canister purge solenoid valve and install the CH-48096  .
  2. Use a scan tool to seal the system.
  3. Use the flow meter on the J 41413-200  calibrated to 0.51 mm (0.020 in) to determine that there is no leak in the EVAP system.
    • If a leak is detected, use the J 41413-200  to apply smoke to the EVAP system at the service port or the filler neck until the leak is located.
scientia non olet · About LEMON Manuals