Conditions for Setting the DTC: P013A

The ECM detects that the time for the sensor voltage to transition from 0.4 to 0.2 volt exceeds 0.4 second.

P013E

• The ECM detects that more than 4 seconds are required from the beginning of DFCO for the sensor voltage to fall below 0.14 volt.

  OR

• The ECM detects that more than 4 grams of integrated air mass have passed through the system since the beginning of DFCO and the sensor voltage remains above 0.14 volt.

P0140

• The ECM detects that the HO2S 2 voltage parameter is between 0.401-0.519 volt, or that the HO2S 2 internal resistance is more than 40,000 ohms while the calculated exhaust temperature is more than 600°C (1,112°F).
• DTC P0140 sets within 4 seconds when the above condition is met for 60 seconds.

P2232

• The ECM detects that the HO2S 2 voltage and the HO2S 2 heater voltage changes are synchronous.
• DTC P2232 sets within 4 seconds when the above condition is met continuously, or within 50 seconds when the above condition is met cumulatively.

P2270

• The ECM detects that the HO2S 2 voltage oscillations are slower than a calibrated value.
• DTC P2270 sets within 4 seconds when the above condition is met continuously, or within 50 seconds when the above condition is met cumulatively.

P2271

• The ECM detects that the HO2S 2 voltage oscillations are faster than a calibrated value.
• DTC P2271 sets within 4 seconds when the above condition is met continuously, or within 50 seconds when the above condition is met cumulatively.