Conditions for Running the DTC
WARNING: This page is about a different car, the 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
P0106 - Engine Cranking
- DTCs P0096, P0097, P0098, P0099, P0107, P0108, P0121, P0122, P0123, P0221, P0222, P0223, P0236, P0237, P0238, P0455, P0496, P2176, P2227, P2228, P2229 are not set.
- The engine OFF timer is greater than 4 seconds before cranking begins.
- The engine is cranking at less than 400 RPM for at least 200 ms.
- This DTC runs once per key cycle within the enabling conditions.
P0106 - Engine Running
- DTCs P0010, P0011, P0013, P0014, P0107, P0108, P0121, P0122, P0123, P0221, P0222, P0223, P0236, P0237, P0238, P0341, P0342, P0343, P0366, P0367, P0368, P2088, P2089, P2090, P2091, P2227, P2228, P2229 are not set.
- The engine is running and the ECM has counted greater than 200 RPM.
- The engine speed is greater than 1,500 RPM once during the drive cycle.
- If start-up ECT is colder than -8°C (+18°F), then the diagnostic is disabled until the ECT reaches 30°C (86°F).
- The change in the MAP Sensor parameter is greater than 10 kPa once during the drive cycle.
- The TP Sensor parameter is less than 25 percent once during the drive cycle.
- This DTC runs continuously within the enabling conditions.