LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 780 (Engine Controls And Fuel - 2.0L - DTC P0010 To DTC P0299) >> DTC P0090, P0091, or P0092 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the high pressure fuel pump.
  2. Engine running, verify that a test lamp flashes between the FRP regulator low circuit terminal 1 and B+.
    • If the test lamp is always ON, test the FRP regulator low circuit for a short to ground. If the circuit tests normal, replace the ECM.
    • If the test lamp is always OFF, test the FRP regulator low circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
  3. Ignition ON, verify that a test lamp illuminates between the FRP regulator high circuit terminal 2 and ground.
    • If the test lamp does not illuminate, test the FRP regulator high circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
  4. If all circuits test normal, test or replace the high pressure fuel pump.
scientia non olet · About LEMON Manuals