Conditions for Running the DTC

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

P0133

DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
The Engine Coolant Temperature (ECT) Sensor parameter is more than 70°C (158°F).
The Ignition 1 Signal parameter is between 10-18 volts.
The Fuel Level Sensor parameter is more than 10 percent.
The Engine Run Time parameter is more than 200 seconds.
The Engine Speed parameter is between 1,000-3,500 RPM.
The Manifold Absolute Pressure (MAP) Sensor parameter is more than 30 kPa.
The Mass Airflow (MAF) Sensor parameter is between 11-50 g/s.
The Loop Status parameter is Closed.
The Throttle Position (TP) Indicated Angle parameter is more than 5 percent.
DTC P0133 runs once per drive cycle when the above conditions are met for 2 seconds.

P0134

DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
The Engine Coolant Temperature (ECT) Sensor parameter is more than 70°C (158°F).
The Ignition 1 Signal parameter is between 10-18 volts.
The engine run time is more than 200 seconds.
DTC P0134 runs continuously when the above conditions are met.

P013A

DTCs P0030, P0036, P0053, P0054, P0101, P0102, P0103, P0106, P0107, P0108, P0120, P0121, P0122, P0123, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P013A, P013B, P013E, P013F, P0140, P0141, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0300, P0442, P0443, P0446, P0449, P0455, P0496, P1133, P1174, P1516, P2101, P2119, P2135, P2176, P2270, P2271, P2A00 are not set
The system voltage is between 10-18 volts.
The learned heater resistance is valid.
The ICAT MAT Burnoff delay is not active
The Green O2 Sensor Condition is not present
The fuel level is more than 10 percent or the fuel level data fault is active.
The engine run time is equal to or more than 40 seconds.
THEN
The decel fuel cutoff (DFCO) is active.
The accelerator pedal position (APP) is stable.
The torque converter clutch (TCC) is locked.
DTCs P013E and P2270 have run and passed.
This DTC runs once per trip.

P013B

DTCs P0030, P0036, P0053, P0054, P0101, P0102, P0103, P0106, P0107, P0108, P0120, P0121, P0122, P0123, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P013A, P013B, P013E, P013F, P0140, P0141, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0300, P0442, P0443, P0446, P0449, P0455, P0496, P1133, P1174, P1516, P2101, P2119, P2135, P2176, P2270, P2271, P2A00 are not set
The system voltage is between 10-18 volts.
The learned heater resistance is valid.
The ICAT MAT Burnoff delay is not active.
The Green O2 Sensor Condition is not present.
The fuel level is more than 10 percent or the fuel level data fault is active.
The engine run time is equal to or more than 40 seconds.
THEN
DTCs P013A, P013E, P013F, P2270 and P2271 have run and passed.
This DTC runs once per trip.

P013E

DTCs P0030, P0036, P0053, P0054, P0101, P0102, P0103, P0106, P0107, P0108, P0120, P0121, P0122, P0123, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P013A, P013B, P013E, P013F, P0140, P0141, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0300, P0442, P0443, P0446, P0449, P0455, P0496, P1133, P1174, P1516, P2101, P2119, P2135, P2176, P2270, P2271, P2A00 are not set
The system voltage is between 10-18 volts.
The learned heater resistance is valid.
The ICAT MAT Burnoff delay is not active.
The Green O2 Sensor Condition is not present.
The fuel level is more than 10 percent or the fuel level data fault is active.
The engine run time is equal to or more than 40 seconds.
THEN
The decel fuel cutoff (DFCO) is active.
The accelerator pedal position (APP) is stable.
The torque converter clutch (TCC) is locked.
DTC P2270 has run and passed.
This DTC runs once per trip.

P013F

DTCs P0030, P0036, P0053, P0054, P0101, P0102, P0103, P0106, P0107, P0108, P0120, P0121, P0122, P0123, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P013A, P013B, P013E, P013F, P0140, P0141, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0300, P0442, P0443, P0446, P0449, P0455, P0496, P1133, P1174, P1516, P2101, P2119, P2135, P2176, P2270, P2271, P2A00 are not set
The system voltage is between 10-18 volts.
The learned heater resistance is valid.
The ICAT MAT Burnoff delay is not active.
The Green O2 Sensor Condition is not present.
The fuel level is more than 10 percent or the fuel level data fault is active.
The engine run time is equal to or more than 40 seconds.
THEN
DTCs P013A, P013E, P2270 and P2271 have run and passed.
This DTC runs once per trip.

P0140

DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
The ECT Sensor parameter is more than 70°C (158°F).
The Ignition 1 Signal parameter is between 10-18 volts.
The Engine Run Time parameter is more than 200 seconds.
The Loop Status parameter is closed.
DTC P0140 runs once per drive cycle when the above conditions are met.

P1133

DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
The ECT Sensor parameter is more than 70°C (158°F).
The Engine Speed parameter is between 1,500-3,500 RPM.
The Ignition 1 Signal parameter is between 10-18 volts.
The Engine Run Time parameter is more than 200 seconds.
The Loop Status parameter is Closed.
The TP Indicated Angle parameter is more than 5 percent.
The Fuel Level Sensor parameter is more than 10 percent.
The MAP Sensor parameter is more than 30 kPa.
The MAF Sensor parameter is between 11-50 g/s.
DTC P1133 runs once per drive cycle when the above conditions are met for 2 seconds.

P2270

DTCs P0030, P0036, P0053, P0054, P0101, P0102, P0103, P0106, P0107, P0108, P0120, P0121, P0122, P0123, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P013A, P013B, P013E, P013F, P0140, P0141, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0300, P0442, P0443, P0446, P0449, P0455, P0496, P1133, P1174, P1516, P2101, P2119, P2135, P2176, P2270, P2271, P2A00 are not set
The system voltage is between 10-18 volts.
The learned heater resistance is valid.
The ICAT MAT Burnoff delay is not active.
The Green O2 Sensor Condition is not present.
The fuel level is more than 10 percent or the fuel level data fault is active.
The engine run time is equal to or more than 40 seconds.
THEN
The DTCs are not active
The engine speed is between 1100-2100 RPM.
The airflow is equal to or more than 3 gps, and equal to or less than 12 gps.
The vehicle speed is equal to or more than 73 km/h (45.4 mph), and equal to or less than 120 km/h (74.6 mph).
The short term fuel trim is equal to or more than 0.9, and equal to or less than 1.065.
The fuel state is in Closed Loop.
The evaporative emission (EVAP) diagnostics are not in control of purge.
The ethanol estimate is not in progress.
The post cell is enabled.
The power take-off is not active.
The exhaust gas recirculation (EGR) diagnostic is not intrusive.
The heater warm-up delay is more than 120 seconds.
The catalytic converter temperature is equal to or more than 650°C (1,202°F) and equal to or less than 900°C (1,652°F).
This DTC runs once per trip when all of the above conditions have been met for 2 seconds.

P2271

DTCs P0030, P0036, P0053, P0054, P0101, P0102, P0103, P0106, P0107, P0108, P0120, P0121, P0122, P0123, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P013A, P013B, P013E, P013F, P0140, P0141, P0171, P0172, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0300, P0442, P0443, P0446, P0449, P0455, P0496, P1133, P1174, P1516, P2101, P2119, P2135, P2176, P2270, P2271, P2A00 are not set
The system voltage is between 10-18 volts.
The learned heater resistance is valid.
The ICAT MAT Burnoff delay is not active.
The Green O2 Sensor Condition is not present.
The fuel level is more than 10 percent, or the fuel level data fault is active.
The engine run time is equal to or more than 40 seconds.
THEN
The decel fuel cutoff (DFCO) is active.
The accelerator pedal position (APP) is stable.
The torque converter clutch (TCC) is locked.
DTC P013A, P013E and P2270 have run and passed.
This DTC runs once per trip.

P2A00

DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, P2176 are not set.
The Engine Run Time parameter is more than 100 seconds.
The Engine speed parameter is between 1,000-3,400 RPM.
The Ignition 1 Signal parameter is between 10-18 volts.
The Mass Airflow (MAF) Sensor parameter is between 10-30 g/s.
The ECT Sensor parameter is more than 70°C (158°F).
DTC P2A00 runs continuously when the above conditions are met for 5 seconds.