LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 775 (HVAC System - Manual) >> Repair Instructions >> Heater and Air Conditioning Control Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument panel (I/P) center trim panel. Refer to Instrument Panel Center Trim Panel Replacement .
    2. Fig 1: View Of HVAC Control Module Assembly
    GM1552388Courtesy of GENERAL MOTORS CORP.
  2. Remove the HVAC control module assembly screws.
  3. Remove the HVAC control module assembly.
    4. IMPORTANT: The HVAC control connector-1 and the radio connector-2 can be interchanged. Mark or place tape on the connector to avoid accidental interchange.
  4. Disconnect the HVAC control module assembly electrical connectors.
scientia non olet · About LEMON Manuals