LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 771 (Tire Pressure Monitoring System) >> Repair Instructions >> Tire Pressure Indicator Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle on a suitable support. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire/wheel assembly from the vehicle. Refer to Tire and Wheel Removal and Installation .
  3. Remove the tire from the wheel. Refer to Tire Dismounting and Mounting .
    4. Fig 1: Identifying Tire Pressure Sensor Components
    GM2042776Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: If any of the following tire pressure sensor components are found to be damage, replace the damaged components
  4. Remove the tire pressure sensor indicator cap (1) and deflate the tire.
  5. Remove tire pressure sensor indicator nut (4).
    6. IMPORTANT: When removing the tire pressure sensor, DO NOT re-use the seal, replace with new.
  6. Remove the tire pressure sensor seal (3), the washer (2) and the tire pressure sensor (1).
scientia non olet · About LEMON Manuals