LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 770 (Manual Transaxle - Mu3) >> Repair Instructions - On Vehicle >> Axle Seals Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Axle Seal
    GM895455Courtesy of GENERAL MOTORS CORP.
  1. Use the J 23907  or J 44809  to install a new seal. See Special Tools . Ensure the seal is seated flush to the outer bore area.
  2. Install the wheel driveshaft or intermediate drive shaft. Refer to Wheel Drive Shaft Replacement or Intermediate Drive Shaft Replacement .
  3. Install the front tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals