Differential Case Assemble

WARNING: This page is about a different car, the 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

87 92 210 Differential Bearing Support. See Special Tools .
J 22919 Differential Side Bearing Installer. See Special Tools .

Fig 1: Exploded View Of Differential Gear Assembly

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Assemble the differential gear assembly by installing the differential case (320) to ring gear (307) using 12 ring gear-to-case bolts (306).
Tighten: Tighten the ring gear-to-case bolts to 20 N.m (15 lb ft) plus 90 degrees.

An option for limited slip differential or open differential exists for some models. See inset. Both differential assemblies are serviced only as a complete assembly. The bolts, ring gear and tapered roller bearings are serviceable components.

Fig 2: Installing Differential Bearings

Courtesy of GENERAL MOTORS CORP.

Press the differential bearings onto the differential assembly using the J 22919 (1). See Special Tools . Use the 87 92 210 (2) under the differential as shown. See Special Tools .
To change the differential bearing races, refer to Clutch Housing Assemble and Transmission Case Disassemble or Transmission Case Assemble .