LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 770 (Manual Transaxle - Mu3) >> Diagnostic Information and Procedures >> DTC P0806 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector of the CPP sensor.
  2. Ignition ON, observe the scan tool CPP sensor voltage parameter for 0.1 volt.
    • If the voltage is below the specified value, replace the CPP sensor.
scientia non olet · About LEMON Manuals