LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 766 (Engine Control System & Fuel System - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying EVAP Canister
    GM1742802Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister vent solenoid valve into the EVAP canister, with the valve aligned to the released position.
    2. Fig 2: Identifying EVAP Canister Vent Valve
    GM1742796Courtesy of GENERAL MOTORS CORP.
  2. Rotate EVAP canister vent solenoid valve clockwise in order to secure it into the locked position.
    3. Fig 3: View Of EVAP Canister Bolt
    GM1652165Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the EVAP canister and bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 4: View Of EVAP Canister Harness Electrical Connector
    GM1652166Courtesy of GENERAL MOTORS CORP.
  4. Connect the EVAP canister harness electrical connector (2) to the vent solenoid valve.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals