LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 766 (Engine Control System & Fuel System - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Engine Coolant Temperature Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.
    Fig 1: Identifying Engine Harness Electrical Connectors - Top Of Engine
    GM1647986Courtesy of GENERAL MOTORS CORP.
  1. Drain the cooling system. Refer to Cooling System Draining and Filling (GE 47716 Fill) or Cooling System Draining and Filling (Static Fill LE5, L61) .
  2. If equipped with regular production option (RPO) MN5, disconnect the engine harness electrical connector (3) from the engine coolant temperature (ECT) sensor.
    3. Fig 2: Identifying Engine Harness Electrical Connectors
    GM1648166Courtesy of GENERAL MOTORS CORP.
  3. If equipped with RPO M86, disconnect the engine harness electrical connector (3) from the ECT sensor.
    4. Fig 3: View Of ECT Sensor
    GM773501Courtesy of GENERAL MOTORS CORP.
  4. Carefully remove the ECT sensor.
scientia non olet · About LEMON Manuals