LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 766 (Engine Control System & Fuel System - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of CKP Sensor Wiring Harness Electrical Connector And CKP Sensor
    GM1656996Courtesy of GENERAL MOTORS CORP.
  1. Remove the starter. Refer to Starter Motor Replacement .
  2. Disconnect the crankshaft position (CKP) sensor wiring harness electrical connector from the CKP sensor.
    3. Fig 2: Identifying CKP Sensor
    GM1578475Courtesy of GENERAL MOTORS CORP.
  3. Remove the CKP sensor bolt.
  4. Remove the CKP sensor.
scientia non olet · About LEMON Manuals