LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 766 (Engine Control System & Fuel System - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Outlet Duct Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of PCV Hose From Outlet Duct
    GM1656106Courtesy of GENERAL MOTORS CORP.
  1. If necessary, install the PCV hose to the outlet duct.
  2. If necessary, position the PCV hose clamp at the outlet duct.
    3. Fig 2: View Of Air Cleaner Outlet Duct
    GM1657019Courtesy of GENERAL MOTORS CORP.
  3. Install the air cleaner outlet duct to the throttle body and air cleaner housing.
    4. NOTE: Refer to Fastener Notice .
  4. Tighten the clamps at the air cleaner housing and throttle body.

    Tighten:  Tighten the clamps to 5 N.m (44 lb in).

  5. Install the push pin retainer.
  6. Install the PCV hose to the camshaft cover.
  7. Position the PCV hose clamp at the camshaft cover.
  8. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals