LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 766 (Engine Control System & Fuel System - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Inlet Duct Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Air Cleaner Intake Duct
    GM1657025Courtesy of GENERAL MOTORS CORP.
  1. Position the air cleaner intake duct.
  2. NOTE: Refer to Fastener Notice .
  3. Install the air cleaner intake duct bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb ft).

  4. Install the air cleaner intake duct retainer.
  5. Install the right front fender liner. Refer to Front Fender Liner Replacement .
  6. Install the right front tire and wheel. Refer to Tire and Wheel Removal and Installation .