LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 766 (Engine Control System & Fuel System - 2.4L - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Harness Electrical Connector To MAF/IAT Sensor
    GM1647998Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the engine harness electrical connector from the mass air flow (MAF)/intake air temperature (IAT) sensor.
  2. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
    3. Fig 2: View Of Air Cleaner Nuts
    GM1657015Courtesy of GENERAL MOTORS CORP.
  3. Remove the air cleaner nuts.
  4. Remove the air cleaner assembly. Pull up the front leg of the housing in order to disengage the housing from the stud.
scientia non olet · About LEMON Manuals