LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 765 (Engine Control System & Fuel System - 2.2L (L61) - Introduction (2 Of 2)) >> Repair Instructions >> Throttle Body Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Throttle Body
    GM1623767Courtesy of GENERAL MOTORS CORP.
  1. Install the throttle body.
    2. NOTE: Refer to Fastener Notice .
  2. Install the throttle body bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    3. Fig 2: Identifying Throttle Actuator Control (TAC) Electrical Connector
    GM1647528Courtesy of GENERAL MOTORS CORP.
  3. Connect the TAC electrical connector (1).
  4. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  5. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Resonator Replacement .
scientia non olet · About LEMON Manuals