LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 765 (Engine Control System & Fuel System - 2.2L (L61) - Introduction (2 Of 2)) >> Repair Instructions >> Knock Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the starter. Refer to Starter Motor Replacement .
    2. Fig 1: View of Knock Sensor
    GM630342Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the knock sensor (KS) harness connector.
  3. Remove the KS retaining bolt.
  4. Remove the KS.
scientia non olet · About LEMON Manuals