LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 765 (Engine Control System & Fuel System - 2.2L (L61) - Introduction (2 Of 2)) >> Repair Instructions >> Knock Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Knock Sensor
    GM630342Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice.
    IMPORTANT: The KS threaded surfaces must be clean before installation.
  1. Install the knock sensor.

    Tighten:  Tighten the knock sensor retaining bolt to 25 N.m (18 lb ft).

  2. Connect the knock sensor harness connector.
  3. Install the starter. Refer to Starter Motor Replacement .
scientia non olet · About LEMON Manuals