LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 765 (Engine Control System & Fuel System - 2.2L (L61) - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Fuel Tank Pressure Sensor
    GM1742792Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel tank pressure sensor to the EVAP canister. Ensure that the sensor grommet is fully seated to the canister.
    2. Fig 2: View Of Fuel Tank Harness Electrical Connector
    GM1652166Courtesy of GENERAL MOTORS CORP.
  2. Connect the EVAP canister harness electrical connector (1) to the fuel tank pressure sensor.
  3. Lower the vehicle.
scientia non olet · About LEMON Manuals