LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 765 (Engine Control System & Fuel System - 2.2L (L61) - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Element Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Exploded View Of Air Cleaner Filter
    GM851250Courtesy of GENERAL MOTORS CORP.
  1. Install the air cleaner filter into the lower air cleaner housing.
  2. Install the upper air cleaner cover to the lower air cleaner housing.
  3. Secure the air cleaner housing cover.
  4. Fig 2: View Of IAT Sensor Harness Connector
    GM851290Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  5. Connect the air cleaner resonator to the air cleaner assembly.

    Tighten:  Tighten the air cleaner intake duct clamp to 5 N.m (44 lb in).

  6. Connect the IAT sensor harness connector.