LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 763 (Manual Transmission Clutch System) >> Repair Instructions >> Hydraulic Clutch Hose/Pipe Replacement (M86) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Clutch Line To Clutch Master Cylinder
    GM1549846Courtesy of GENERAL MOTORS CORP.
  1. Remove the UBEC. Refer to Underhood Electrical Center or Junction Block Bracket Replacement .
    2. NOTE: Refer to Brake Fluid Effects on Paint and Electrical Components Notice .
  2. Place a shop towel under the clutch master cylinder and brake master cylinder reservoir in order to catch any additional fluid loss.
  3. Disconnect the clutch hose (1) from the clutch master cylinder and brake master cylinder reservoir.
  4. Disconnect the clutch line (2) at the clutch actuator cylinder and the transaxle and drain the fluid into a suitable container.
scientia non olet · About LEMON Manuals