LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 760 (Drum Brake System) >> Repair Instructions >> Rear Brake Backing Plate Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the brake drum. Refer to Brake Drum Replacement .
    4. Fig 1: View Of Brake Drum Universal Spring
    GM891442Courtesy of GENERAL MOTORS CORP.
  4. Remove the brake shoes. Refer to Brake Shoe Replacement 
  5. Remove the universal spring (1) from the brake backing plate.
  6. Remove the wheel cylinder. Refer to Wheel Cylinder Replacement .
    7. Fig 2: View Of Rear Park Brake Cable End Fitting
    GM890720Courtesy of GENERAL MOTORS CORP.
  7. Release the rear park brake cable end fitting (1) from the drum brake backing plate.
    8. Fig 3: View Of Wheel Bearing/Hub Assembly
    GM900071Courtesy of GENERAL MOTORS CORP.
  8. Remove the wheel bearing/hub assembly. Refer to Rear Wheel Bearing and Hub Replacement (Drum Brake) .
  9. Remove the brake backing plate.
scientia non olet · About LEMON Manuals