LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 760 (Drum Brake System) >> Repair Instructions >> Rear Brake Backing Plate Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wheel Bearing/Hub Assembly
    GM900071Courtesy of GENERAL MOTORS CORP.
  1. Install the brake backing plate.
  2. Install the wheel bearing/hub assembly. Refer to Rear Wheel Bearing and Hub Replacement (Drum Brake) .
    3. Fig 2: View Of Rear Park Brake Cable End Fitting
    GM890720Courtesy of GENERAL MOTORS CORP.
  3. Secure the rear park brake cable end fitting (1) to the brake backing plate.
    4. Fig 3: View Of Brake Drum Universal Spring
    GM891442Courtesy of GENERAL MOTORS CORP.
  4. Install the wheel cylinder. Refer to Wheel Cylinder Replacement .
  5. Install the universal spring (1) to the backing plate.
  6. Install the brake shoes. Refer to Brake Shoe Replacement .
  7. Adjust the drum brakes. Refer to Drum Brake Adjustment .
  8. Install the brake drum. Refer to Brake Drum Replacement .
  9. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Pressure) or Hydraulic Brake System Bleeding (Manual) .
  10. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  11. Lower the vehicle.
scientia non olet · About LEMON Manuals