LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 760 (Drum Brake System) >> Repair Instructions >> Drum Brake Hardware Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Brake Drum Universal Spring
    GM891442Courtesy of GENERAL MOTORS CORP.
  1. Install the universal spring (1) to the brake backing plate.
    2. Fig 2: Using J 38400 To Pull Universal Spring
    GM900069Courtesy of GENERAL MOTORS CORP.
  2. Position the hook end of the J 38400  (1) under the universal spring and lightly pull the universal spring end out while installing the leading brake shoe. See Special Tools . Ensure that the universal spring engages the brake shoe web hole.
    3. Fig 3: Pulling Universal Spring End Out Of Shoe Web Hole
    GM890726Courtesy of GENERAL MOTORS CORP.
  3. Position the hook end of the J 38400  (1) under the universal spring and lightly pull the universal spring end out while installing the trailing brake shoe. See Special Tools . Ensure that the universal spring properly engages the brake shoe web hole.
  4. Install the brake drum. Refer to Brake Drum Replacement .
  5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals