LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Cobalt LTZ >> Repair and Diagnosis >> External Pages >> Different car >> Section 760 (Drum Brake System) >> Repair Instructions >> Drum Brake Adjusting Hardware Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Brake Shoe Adjuster Assembly Using Special Tool
    GM890724Courtesy of GENERAL MOTORS CORP.
  1. Using the J 38400  (1), spread the top of the brake shoes apart. See Special Tools .
  2. Install the adjuster assembly (2) to the brake shoes.
    3. Fig 2: View Of Drum Brake Adjusting Hardware
    GM891440Courtesy of GENERAL MOTORS CORP.
  3. Install the adjuster actuator lever (2) to the brake shoe and the adjuster assembly (3). Ensure that the lever is properly engaged between the adjuster assembly and the brake shoe.
    4. NOTE: Do not over stretch the adjuster spring. Damage can occur if the spring is over stretched.
  4. Install the adjuster spring (1). Ensure that the loop end of the spring fully engages the tab on the actuator lever (2).
  5. Adjust the drum brakes. Refer to Drum Brake Adjustment .
  6. Install the brake drum. Refer to Brake Drum Replacement .
  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals